· Quick video showing how to manually lock the vacuum actuated hubs on Ford Superduty as well as a brief explanation on different 4x4 www.doorway.ru else do you. · How do you stick a four-wheel drive super duty F in 4- wheel drive manual locking hubs? Ummm. You go to each front wheel and turn the hub clockwise to the locking position as indicated: Then, get in the truck. Start the motor. Put in the clutch or leave it in Park or Neutral, then use the transfer case lever to shift into 4 High or 4 Low. · As long as the transfer case stays in a four-wheeled drive, the hub remains in the locked position, too. When you switch it to a two-wheeled drive, the clutch mechanism comes into play to release the hub by sliding back out. The ultimate result is that the wheels become independent of its axle shaft – and that’s it!
manual hubs is a good excuse to stop/get out for a breather (locking/unlocking) auto hubs club member had his auto hubs gone thru prior to TDS-- miles down the road, came to the first dirt hill one hub didn't work!!! the 'mechanic' put it together wrong and BROKE it!! then again-- most everybody has a spare manual hub that could be. Selecting 4WD in a car with manual locking hubs involves two steps. The first one is physically turning the hub handle to set it on locked. After the actuator is set to lock, you have to select High 4X4 or Low 4X4 in the car to operate in 4WD. Auto-Locking Hubs How Do Auto-Locking Hubs Work? Several auto-locking hub designs work differently. I hate tht I do not have locking hubs on my jk. This is the first 4x4 that I have had without them. It is nice to put your transfer case in 4x4 and use your low range without locking your hubs to get 2wd. Back before the newer oils and bearings locking hubs saved a lot of wear and helped on gas mileage.
With the new style auto locking hub you can select 4WD by moving the gear stick into H4 or L4, but you can only do this when the vehicle is stationary. This is now done electronically as you select 4WD, if the electronics fail and you can’t select 4WD and you have the new style hubs you can manually lock the hubs by using the wheel brace to turn the nut in the centre of the hub to the lock position. Website: www.doorway.ru() Sales() SupportEmail: info@www.doorway.ru By the way, locking hubs do not create more traction. They are not to be confused with differential locks! In 2WD with locking hubs disengaged rear drive shaft, rear differential and rear axle are rotating. Front tires are rolling along - only rear tires are pulling. Red lines indicate rotating parts.
0コメント